99EUR

Here's how our new two-section BOOSTER works.

It can be used it two different configurations, either as a typical "booster"or as giving completely new possibilities two-section BOOSTER .
The two-section option allows connect each of the sections in different points throughout the effects chain.
The first section is designed to increase the sound saturation and should be plunged into input of the amplifier, preamp or at the beginning of effects chain,
while the second section is designed to increase the volume and is plugged after preamp or straight into FX LOOP of the amplifier or at the end of effects chain.

What is it for?
Sometimes you need to increase distortion's saturation and volume by pressing just one foot-switch. Using a classic single-circuit booster plugged into input of the amplifier, preamp or effects chain, you get more saturation.
But, in the case when your sound is already heavily distorted, despite the greater "boost", the signal level remains the same, so the guitar does not come forward, is not vivid enough in the band's mix. If you want to increase the volume level, you should use an additional BOOST section plugged at the end of the effects chain, after preamp or at the input of power amp section (FX LOOP).
This is what our two-section booster is for.
 

Summary 
With our BOOSTER the effect of the typical "booster"can be achieved, while greatly increasing the signal level of the guitar in solo parts.
The GAIN adjustment range is so large that when the GAIN is set to minimum,
the Booster doesn't overloads signal thus is not  interfering with sound character.
On the other hand, increasing the GAIN level allows to get characteristic tube like compression with greater sound saturation and greater sustain.

MultiWAY  BOOSTER

Features:
 

• MODE 1-Way / 2-Way:  operating mode selector switch

• Pre BOOST GAIN: sound saturation level at the input section.

• Post BOOST VOLUME - volume level of the output section.

• POWER SUPPLY 9V-15V: any power supply with power rating
  between 9 and 15V can be used.

• Current consumption:  50mA max

• POLARITY AUTO DETECTION: allows using either centre-positive or 
  negative polarity on power supply.

• DC ASSISTANT: protection against signal loss. If disconnected or the voltage is lower then 6V the effect is automatically switched to the "bypass" mode

• TRUE-BYPASS  - in OFF mode your instrument’s original signal goes through, bypasses all electronic components.

• DIMENSIONS: (H x W x D) 50 x 66 x 100mm

• WEIGHT: 0,4kg

Taurus Custom

Taurus Effects Pedals Servo, Drive, Multidrive, Tux compressor, Beefmaster, MultiWay Booster

Designed by musicians for musicians